Washer repair in Miami and South Florida

Most no-drain calls trace back to a clogged drain pump filter, a failed drain pump motor, or a kinked drain hose. On front-loaders it is often a sock or coin lodged in the pump. Berne Appliance Repair clears or replaces the pump on the same visit for most major brands.

Typical washer repairs run $160 to $420 including parts and labor. The $59 service call covers diagnosis and is waived if you approve the repair. Control-board failures on high-end front-loaders sit at the upper end of the range.

Yes, our technicians service every common configuration: front-load, high-efficiency top-load, traditional agitator top-load, and stacked laundry-center units. We carry door boots, drain pumps, and shock absorbers on the truck for fast same-visit fixes.

If your washer is under eight years old and the quoted repair is below half the price of a comparable new unit, repair almost always wins. Berne Appliance Repair will tell you up-front if a unit is not worth fixing rather than pushing unnecessary parts.

We service Samsung, LG, Whirlpool, Maytag, GE, Speed Queen, Bosch, Electrolux, Frigidaire, and Kenmore, plus premium European brands like Miele and Asko. Call (754) 345-4515 with your model number for parts confirmation.

Underbody leaks usually come from a torn door boot (front-load), a cracked tub-to-pump hose, or a failed pump seal. A Berne Appliance Repair technician will pinpoint the leak with the unit running on a $59 service call and replace the failed part the same day in most cases.

Yes, we keep dedicated Broward routes Monday through Saturday and most washer calls placed before noon get a same-day slot. Book directly at (754) 345-4515.

A UE code on Samsung or LG front-loaders means the drum could not balance the load during spin. First step is redistributing the laundry — heavy items on opposite sides. If the code keeps coming back with normal loads, the suspension rods or shock absorbers have lost damping and need replacement as a set. Bearing failure is the next suspect.

Yes, and the cause is usually biofilm buildup in the door gasket folds, the dispenser drawer, and behind the drum baffle on front-loaders. We can pull the dispenser and clean the visible buildup on a service call. For a full clean we lift the tub on a separate visit. Habit change matters too: hot cycles weekly and door left open between loads keep it from coming back.

A well-maintained front-loader runs 10 to 12 years; top-loaders with agitators often hit 14 to 18 years before bearings or transmissions retire them. South Florida humidity and hard water shorten that range slightly — gaskets and inlet valve screens fail earlier here than in drier climates. Regular descaling and gasket wipe-downs add 2 to 4 years.

On a unit that is under seven years old, yes — a bearing kit plus the labor runs $380 to $620 depending on brand. On a 10-plus year old washer, we will tell you straight that a $600 bearing job rarely makes sense against a new unit. We give the honest call, not the parts-sale.

Parts we install are covered up to 10 years on sealed-system welds, up to 2 years on mechanical parts, and up to 1 year on electronic and electrical parts. Labor is warranted 90 days — if the same component goes again within that window we return at no charge (no diagnostic fee, no labor).