Skip to main content

LG Dryer Repair

4.79★ · $59 service call · same day

Same-day slots most days, 7 AM–9 PM. 19 factory-trained technicians, 4.79★ across 1,209 customer reviews — the $59 service call is waived when you proceed with the repair.

Request service
Berne technicians

LG dryer repair across Miami-Dade, Broward and Palm Beach. Electric DLEX and gas DLGX models, WashTower, heat pump and ventless compacts. Not heating, D80, D90, D95 flow codes, tE1, tE2, dE, thermal fuses, elements, rollers, belts. LG Authorized Service Center. $59 service call, free with the repair · 4.79★ · same-day slots most days.

LG dryers are the only ones on the market that tell you when the vent is the problem: the D80, D90 and D95 codes mean the dryer measured its own airflow and found the duct blocked by that percentage. Most owners ignore the code until the dryer stops heating, and by then the thermal fuse has blown for exactly that reason. Berne has been an LG Authorized Service Center since July 2026, which means factory parts, LG’s diagnostic mode, and warranty repairs billed to LG when the unit qualifies. The DLEX and DLGX platforms share most parts with each other and with the WashTower dryer half, so the truck stock covers nearly every call.

LG dryer models we repair

  • Electric DLEX3370, DLEX3570, DLEX3700, DLEX3900, DLEX4000, DLEX4200, DLEX4500, DLEX6700
  • Gas DLGX3371, DLGX3701, DLGX3901, DLGX4001, DLGX4201, DLGX6701
  • WashTower WKEX200, WKHC202, WKGX201 dryer section
  • Heat pump and ventless DLHC1455, DLHC5502 compacts
  • Older DLE and DLG series with the front lint filter
  • Studio and Signature series

LG dryer codes and symptoms

D80, D90 or D95: the vent is blocked
LG’s Flow Sense measured the exhaust and found it 80, 90 or 95 percent restricted. The dryer is not broken yet. We clean the vent to the outside where the run allows, measure the airflow after, and tell you if the duct itself needs rebuilding. A South Florida condo run of thirty feet through the ceiling will show D90 within two years if nobody cleans it.
Runs but no heat
Electric DLEX: the heating element or the thermal fuse on the heater housing, and the fuse blew because the vent was blocked. Gas DLGX: the igniter, the flame sensor or the valve coils. We meter in that order and check the airflow before leaving, because the fuse will blow again in a dryer that cannot breathe.
tE1, tE2 or tE3: thermistor
The temperature sensor at the heater or in the exhaust duct has failed or its connector corroded. A $30 part, an hour of labor, and the dryer heats again.
Squeal, thump or grinding on rotation
Drum rollers, the idler pulley or the rear drum bearing. LG rollers wear flat spots around year six and thump on every turn. We replace rollers, pulley and belt as a set with the drum out, so the part we left does not start the noise again.
dE, dE4 or door open message
Door switch or a door that has sagged on its hinge so the switch no longer closes. The switch is a same-visit part; the hinge is a five-minute adjustment when that is all it is.
Will not start, hums, or spins free with no drum movement
A snapped belt, a failed belt switch, or the drive motor. Belts are truck stock on every LG platform.
Heat pump dryer takes hours, water in the reservoir tray
Ventless and heat pump compacts need the condenser coil cleaned and the drain pump working. A coil packed with lint doubles the cycle time. Cleaning is routine maintenance; a failed condensate pump is a part.
Sensor dry ends early, clothes damp
Moisture sensor bars coated with dryer-sheet film, or a failed sensor harness. Cleaning the bars is part of the visit.

LG dryer repair pricing

JobTypical range*
Service call (applied to the repair)$59
Thermal fuse or high-limit thermostat$130 to $220
Thermistor (tE1, tE2)$130 to $220
Heating element, electric$180 to $330
Igniter, flame sensor or valve coils, gas$160 to $300
Door switch (dE)$130 to $230
Drum belt$150 to $250
Rollers, idler pulley and belt, set$240 to $410
Drive motor$290 to $470
Main control board$270 to $450
Heat pump condenser cleaning$160 to $280
Dryer vent cleaning to the exterior (D80 to D95)$140 to $320

*Parts and labor, residential. Written quote after the diagnosis; the $59 service call is free with any repair you approve. 90-day labor warranty. In-warranty LG repairs are billed to LG under our authorized service agreement.

LG dryer warranty

LG covers the whole dryer for one year and the drum motor for ten years on most DLEX and DLGX models. A dryer that hums and will not turn on a six-year-old unit may be a motor under part warranty, in which case you pay labor only. Bring the serial number or the receipt; as an authorized center we file the claim directly.

Repair or replace

An LG dryer is almost always worth repairing under twelve years, because the parts that fail cost a fraction of the machine and the motor is covered for ten years. The exception is a control board and a motor failing together on an out-of-warranty unit past ten years. A WashTower dryer half cannot be replaced alone, so repair is the answer there at nearly any age.

Frequently asked questions

Do you repair LG dryers in Miami and Broward?
Yes, across Miami-Dade, Broward and Palm Beach, seven days a week, electric, gas, WashTower and heat pump. Berne is an LG Authorized Service Center. Same-day slots most days at (754) 345-4515.
What does D90 mean on my LG dryer?
The exhaust duct is about 90 percent blocked. The dryer is warning you before it breaks. Vent cleaning runs $140 to $320; ignore it and the thermal fuse blows next, which adds a part to the bill.
Why is my LG dryer running but not heating?
Electric: the heating element or thermal fuse, $130 to $330. Gas: igniter, flame sensor or valve coils, $160 to $300. The vent is checked in every heating repair because a blocked vent is what blew the fuse.
My LG dryer thumps on every turn. What is that?
Drum rollers with flat spots, or the idler pulley. We replace rollers, pulley and belt as a set with the drum out, $240 to $410.
Is my LG dryer motor under warranty?
On most DLEX and DLGX models the drum motor is covered for ten years from purchase, part only. We check the serial and file with LG directly, so a motor job on a six-year-old dryer costs labor, not the part.
Do you work on LG WashTower dryers?
Yes. The WashTower dryer half uses the DLEX platform parts, and access is from the front and top, so the unit stays in its closet.

Related: dryer repair, LG appliance repair, LG washer repair, Samsung dryer repair, washer repair.

Request service

By submitting you agree to be contacted by phone or SMS about your service request. No marketing messages.

Call (754) 345-4515