Tappan Appliance Repair in Miami & South Florida

Your Tappan wall oven in a 1990s Kendall house refuses to heat past 200 degrees, but the surface burners on the cooktop still work. Tappan is an older American brand that lived under Frigidaire/Electrolux ownership for decades, and there are still thousands of Tappan wall ovens, ranges, and cooktops working in South Florida homes built in the 70s, 80s, and 90s. Parts availability through the Frigidaire network keeps these units serviceable. Call (754) 345-4515.

About Tappan

Tappan was an American appliance manufacturer founded in 1881, became part of White Consolidated Industries, and then merged into Electrolux when Electrolux acquired White’s appliance division. The Tappan brand still appears on some Frigidaire/Electrolux value-tier units. In South Florida, you’ll find legacy Tappan ranges, cooktops, and wall ovens in homes that haven’t done a major kitchen renovation since the 80s or 90s — Pinecrest, Coral Gables, Westchester, parts of South Miami. Service for these units is straightforward because parts cross-reference through the Frigidaire/Electrolux pipeline.

Common Tappan Problems We Fix

Our techs see roughly the same handful of failure modes year after year on Tappan. A few that come up most often:

• Wall oven bake element burn-out — element glows orange at one spot, then fails. $189-$310 element + labor.
• Wall oven sensor (F3 or F-error) failure. Sensor probe in the cavity reads wrong. $189-$245.
• Range surface element burn-through (coil models). $145-$210 per element.
• Range oven igniter weakness on gas models. Igniter glows but doesn’t reach light-off temperature. $189-$260.
• Cooktop surface element terminal block corrosion. Element won’t heat or trips a breaker. $189-$285.
• Range clock/timer board failure. Display blank or stuck. $245-$385 board.
• Range thermostat calibration drift. Oven runs 25-40 degrees off setpoint. Thermostat replacement $245-$330.

South Florida Service Areas

We service Tappan across Miami-Dade and Broward, with most calls landing in Coral Gables, Pinecrest, Palmetto Bay, Key Biscayne, Brickell, Coconut Grove, Aventura, Bay Harbor Islands, Sunny Isles Beach, and Bal Harbour. Up in Broward we cover Fort Lauderdale’s Las Olas and Harbor Beach neighborhoods, Hillsboro Beach, Lighthouse Point, and Weston. We also reach Palm Beach for larger jobs and standing service contracts. We carry common Tappan parts on the truck so most calls finish first-visit.

What to Expect

The service call is $59, free if you move forward with the repair. We give you a two-hour arrival window and text when the tech is 30 minutes out. Every tech who works on Tappan understands the platform — we don’t farm out specialty brands to generalists. Most jobs finish in a single visit; sealed-system or specialty-part work that requires ordering may require a return visit.

FAQ

Is Tappan still made?
Tappan as a brand still appears on some Frigidaire/Electrolux-built value units, but the original Tappan factory closed decades ago. Parts and service continue through Frigidaire’s network.

Are 30-year-old Tappan ranges worth repairing?
Often yes if the repair is under $400 and the rest of the unit (chassis, oven cavity, surface elements) is in good shape. Many of these units have a 40-year service life with periodic repair.

Do you stock Tappan parts?
Common service parts ride on the truck — elements, igniters, sensors, surface element terminal blocks. Less-common parts are usually 5-10 business days.

Can you recalibrate an old Tappan thermostat?
Yes — we use a thermocouple inside the cavity to measure actual temp and dial in calibration on the thermostat. Where the thermostat is too worn, we quote replacement.

Will you work on Tappan wall ovens in custom cabinetry?
Yes. Most older Tappan wall ovens slide out of the cabinet on adjustable brackets, which makes access manageable.

Tappan Maintenance Notes

Tappan wall ovens benefit from yearly door-hinge tension checks. The self-closing hinges on the older Tappan ovens weaken over time and a sagging door breaks the heat seal. We service hinges as part of routine work.

For coil-element cooktops, check the surface element terminal blocks every 12 months — green oxide on the terminals causes intermittent heat or breaker trips. Clean with a wire brush, replace the block if pitting is severe.

For gas ranges, check the burner igniters annually for spark strength. Weak igniters fail to light reliably and are easy to replace before they fully fail.

Tappan Repair Pricing in South Florida

Realistic price ranges for the most common repairs:

• Wall oven bake element: $189-$310
• Oven sensor (F3): $189-$245
• Coil surface element: $145-$210
• Gas oven igniter: $189-$260
• Surface terminal block: $189-$285
• Clock/timer board: $245-$385
• Thermostat replacement: $245-$330

These are typical ranges, not promises. Every job gets a written estimate before any work starts.

Servicing Legacy Tappan Wall Ovens

A meaningful percentage of Tappan service calls in South Florida involve wall ovens installed in the 1980s and 1990s in Pinecrest, Coral Gables, South Miami, and Coconut Grove. These units were typically installed in custom cabinetry that was sized to the specific Tappan model — a like-for-like replacement is rarely possible without cabinet modification.

When the repair cost approaches $500 and the unit is past 30 years old, we have an honest conversation with the homeowner about replacement strategy. In most cases, the cabinet can be modified to accept a modern wall oven of similar dimensions, but the project involves coordinating a cabinetmaker and possibly an electrician.

For homeowners committed to keeping the original Tappan unit running, we source parts through the Frigidaire cross-reference and through specialty parts dealers who carry NOS (new-old-stock) Tappan components. Most repairs are achievable.

Call Berne for Tappan Repair

Call (754) 345-4515 or schedule online and we’ll have a tech at the door, usually same-day. We stock OEM Tappan parts and stand behind every Tappan repair with a 90-day labor warranty.

Tappan Error Code Reference

The codes below show up most often on Tappan service calls across Miami-Dade, Broward, and Palm Beach. Reading the code first saves diagnostic time and helps us bring the right OEM part on the truck. If your unit shows a code that’s not in this table, call (754) 345-4515 and we’ll walk through the code with you.

Tappan Models We Service

Tappan runs a wide model catalog. The list below covers the SKUs we see most often on South Florida service calls. If your model isn’t here, we still service it — most Tappan SKUs share parts platforms across model years and tier lines.

• TEF351EWB (electric coil range 30-inch)
• TGF367ASD (gas range 30-inch)
• TEF367ASF (electric smoothtop range)
• TES630FS (wall oven single 30-inch)
• TEC3024BD (cooktop 30-inch coil)
• TFC07M0AW (compact freezer 7 cu ft)
• TRT15DG5JW (top-freezer 15 cu ft legacy)

Where Tappan Lives in South Florida

1970s-90s legacy installation. Tappan wall ovens hide in 1970s-90s Pinecrest ranches, Coral Gables mid-century homes, South Miami split-levels, and Coconut Grove restoration houses. The original cabinet openings were sized to the specific Tappan model, so like-for-like replacement is rarely possible without cabinet rework. Most homeowners keep the unit running with periodic service for as long as parts remain available.

Tappan Service Interval Recommendations

The cadences below come from our field experience on Tappan in South Florida — humidity, salt air, and high-traffic family kitchens push intervals tighter than the manufacturer manuals usually publish.

Tappan and the South Florida Climate

Tappan range surface-element terminal blocks corrode faster in Miami than in dry markets. The humidity drives green copper oxide on the terminal connections, which causes intermittent heating and occasional breaker trips. Annual cleaning with a wire brush and dielectric grease application extends terminal-block life by 5-10 years on coastal installations.

Tappan Extended Repair Pricing

Pricing below is the working range our techs see on Tappan in 2026 across South Florida. The bottom of each range is a straightforward part-swap; the top accounts for harder access, additional diagnostics, or rare-stock parts that require special-order fulfillment.

What Happens on the First Tappan Visit

Every Tappan call starts the same way. The tech confirms the model and serial number on the data plate, photographs the install for the file, and asks two or three diagnostic questions before pulling the unit. Bringing the right error code, the unit’s age, and any recent power events (lightning, brown-out, breaker trip) to the call cuts diagnostic time roughly in half. Most Tappan repairs finish on the first visit if the model is current production and the failure matches a common pattern. Sealed-system work, control-board replacements, or specialty parts that need to ship from outside our local warehouse can stretch to a return visit.

Before the tech leaves, you get a written estimate with the part number, the labor charge, the warranty coverage, and the expected completion date if a part needs to be ordered. We don’t charge for the estimate beyond the $59 service call (which applies to the repair if you approve the quote). If the unit isn’t worth repairing — which happens occasionally on Tappan units past 12-15 years — we say so plainly and refund any deposit beyond the service call. Honest repair-vs-replace math is a core part of how we work.

Tappan Service Across South Florida Neighborhoods

Our Tappan dispatch covers all of Miami-Dade County, all of Broward County, and the populated portions of Palm Beach County. The highest-volume Tappan ZIP codes in our records are 33156 (Pinecrest), 33176 (Kendall), 33133 (Coconut Grove), 33134 (Coral Gables), 33139 (Miami Beach), 33301 (Fort Lauderdale Las Olas), and 33019 (Hollywood beach). We hit Aventura and Sunny Isles Beach (33160, 33180) on morning routes from our Aventura staging point. Brickell and downtown Miami (33131) come from the Coral Gables dispatch. Hallandale Beach and Hollywood (33009, 33019, 33020) come from the Hollywood dispatch.

For Palm Beach county we schedule Tappan service in Boca Raton, Delray Beach, Boynton Beach, and West Palm Beach with at least 24 hours of lead time. The drive from Aventura adds 35-50 minutes and we route Palm Beach calls in afternoon blocks to minimize windshield time. Same-day Palm Beach service is possible when the calendar allows it but isn’t guaranteed.

More Tappan Questions We Get

Is Tappan still in production?
The brand still appears on some Frigidaire/Electrolux value units sold through specific retail channels. The original Tappan factory closed decades ago; the badge persists.

Where do I find the model number on a Tappan wall oven?
On the door frame inside the cavity, visible when the door opens, on a metal plate. On ranges, behind the storage drawer at the bottom.

Can a 1980 Tappan range be calibrated to modern standards?
Yes within roughly +/- 25F. We use a thermocouple probe inside the cavity to measure actual temp at 350F, then adjust the thermostat calibration screw. Older mercury-bulb thermostats may need replacement if drift exceeds 50F.

Are Tappan parts cross-referenced to Frigidaire?
Most consumables yes — surface elements, sensors, igniters, bake elements. Specialty parts like specific knobs and trim may require NOS sourcing through specialty dealers.

How long does a Tappan wall oven last?
30-50 years is common with periodic service. The chassis and cavity are built simply; consumables can be replaced as they wear.

Need Tappan service today? Call (754) 345-4515 or book online. We bring the parts on the truck, give you a written estimate before any work, and stand behind every Tappan repair with a 90-day labor warranty.