Range, stove, cooktop and oven repair in Lauderdale Lakes
Gas burner won't light, oven not heating, electric coil only on high, or self-clean stuck? We service Wolf, Viking, Thermador Pro Harmony, Bosch Benchmark, KitchenAid and GE Monogram ranges across South Florida. Same-day diagnostic visits.
Lauderdale Lakes, Broward County • Local range and stove service
What range and stove repair looks like in Lauderdale Lakes
Lauderdale Lakes is inland central Broward, so the recurring issues are heat-load on condensers and dryer-vent lint buildup in the area dense apartment and townhome stock.
As an inland Broward community, Lauderdale Lakes sees more heat-and-dust load on condensers and vents than salt corrosion, which shapes how we approach range and stove repair here.
Do you offer same-day range and stove repair in Lauderdale Lakes?
Yes. Berne Appliance Repair runs same-day range and stove service across Lauderdale Lakes, including Oakland Park Boulevard, State Road 7, Somerset. Book before midday and we can usually have a technician at your door the same afternoon. The $59 diagnostic fee is waived when you proceed with the repair.
Which ZIP codes around Lauderdale Lakes do you cover?
We routinely handle range and stove repair in ZIP codes 33309, 33311, 33313, 33319, plus the surrounding Broward area. If your ZIP is not listed, call us — our coverage is wider than the codes shown here.
range and stove repair near Lauderdale Lakes
We also serve Lauderhill, North Lauderdale, Oakland Park and the rest of Broward County.
What kind of problems are we working with?
Uneven Heating
On gas burners uneven flame is almost always a clogged burner cap or a partially blocked orifice—pull the cap, soak in vinegar, blow out the venturi. On electric coil/ceramic, one element pulls less than spec (a working 2,400W burner draws ~10A at 240V; under 6A the element or surface relay board is failing). Wolf and Thermador Pro Harmony units use sealed brass burners that rarely clog but the spark module fails. Burner service typically $140–220.
Temperature Inaccuracy
Oven swings more than ±25°F across the cycle—that’s the oven sensor (RTD) drifting or the bake/broil relay sticking on the control board. The sensor reads roughly 1,080Ω at room temp and ~1,720Ω at 350°F; outside that range, swap it. Wolf DF36 and Viking VGSC dual-fuel ovens share a 2-pin RTD; KitchenAid and GE Profile use a 2-wire that mounts through the back wall. Sensor + recalibration typically $200–280.
Ignition Problems
Constant tick-tick on one burner with no flame is the spark module locked on or the burner cap is wet—dry it and the click stops. If no burner sparks at all the module itself or the door safety switch is dead. We check spark module output at 6–12kV (visible jump across an air gap) and inspect the igniter electrodes for cracked porcelain. Bosch Benchmark, Thermador Pro, and Wolf DF use a re-ignition module. Module swap typically $180–260.
Oven Not Heating
Gas oven igniter is the #1 part on a service call—glow-bar igniters degrade over time and stop pulling enough current (under 3.2A) to open the safety valve, so the oven clicks, glows weak orange, and never lights. Whirlpool/Maytag use 4342528 family; Wolf and Viking use a different mount with the same theory. Electric ovens drop the bake element first; a healthy 240V element reads 19–25Ω. Igniter or element job typically $190–270.
Gas Odors
Faint gas smell with the range off is almost always the regulator pigtail or a burner valve packing—we pressure-test the manifold with a manometer (should hold 7–11" w.c. for natural, 11–14" for LP). Strong smell at the wall behind the range we shut off at the valve and refuse to leave until it’s tight. Wolf, Viking, and Thermador commercial-style units use brass manifolds that handle leak repairs cleanly. Leak service typically $180–280 depending on the joint.
How to fix your machine?
Describe the Cooking Issue
Oven not heating, gas burner won't light, electric coil only on high, display fault, self-clean stuck short description plus the brand and model speeds up the diagnostic.
Gas, Electric & Induction All Covered
Wolf and Viking ranges, Thermador Pro Harmony, Bosch Benchmark induction, KitchenAid 30-inch convection we work all platforms. EPA 608 certified for sealed-system issues.
Igniters, Bake Element, Control Board, Hinges
Glow-bar igniters, bake elements, oven door hinges and gas valves are all on the truck. Convection fan motors and main board replacements are scheduled separately.
Self-Clean & Pro-Style Specifically
Self-clean cycle door-lock failures and Pro-style range vibration issues are our daily work. We carry Wolf and Viking-specific door springs.
Calibration & Bake Test
We run a 350F bake test for 20 minutes to verify temperature accuracy, then check the broiler. Followup call within 48 hours.
Need appointment?
Comments from our customers
